Mhedzisiro yeiyo viscosity yeinopisa inonamira glue inonamira pahunhu hweglue

Muchokwadi, hupamhi hwemukati hwetsono yeguruu dispenser inofanira kunge iri 1/2 yeupamhi hwenzvimbo yekupa. Iyo otomatiki guruu muchina ine yakakwira hunyanzvi zvemukati, asi mutengo wakakwira!

Iko viscosity uye viscosity yeguruu zvinokanganisa iyoguruu quality of the guruu dispenser.

 

Manualdistribution, iyo otomatiki sikuru muchina inotora musimboti we manualdistributor kugovera zvigadzirwa zvemagetsi, maitiro acho ari nyore, mutengo wakaderera, uye kusanzwisisika kutambisa basa!

 

The principle of the automatic dispenser is to push out the guruu with air pressure within a set time.

 

Just choose the appropriate syringe according to the air pressure, time, and you can easily change the volume of each injection. This can ensure the quality of guruu dots and improve production efficiency. When the viscosity is high, the guruu spots can be reduced, and even wire drawing can be performed. If the viscosity is small, the guruu spots can be increased and the pads can leak. The time of each infusion is controlled by the instrument to ensure that the amount of each infusion is the same. When distributing, you should choose the dispensing needle according to the size of the gasket on the PCB. Choose the same needle but different phase difference gaskets should choose different dispensing needles.